Home
AudioAsylum Trader
Propeller Head Plaza

Technical and scientific discussion of amps, cables and other topics.

For Sale Ads

FAQ / News / Events

 

Use this form to submit comments directly to the Asylum moderators for this forum. We're particularly interested in truly outstanding posts that might be added to our FAQs.

You may also use this form to provide feedback or to call attention to messages that may be in violation of our content rules.

You must login to use this feature.

Inmate Login


Login to access features only available to registered Asylum Inmates.
    By default, logging in will set a session cookie that disappears when you close your browser. Clicking on the 'Remember my Moniker & Password' below will cause a permanent 'Login Cookie' to be set.

Moniker/Username:

The Name that you picked or by default, your email.
Forgot Moniker?

 
 

Examples "Rapper", "Bob W", "joe@aol.com".

Password:    

Forgot Password?

 Remember my Moniker & Password ( What's this?)

If you don't have an Asylum Account, you can create one by clicking Here.

Our privacy policy can be reviewed by clicking Here.

Inmate Comments

From:  
Your Email:  
Subject:  

Message Comments

   

Original Message

RE: Instantaneous current demand and wire gauge?

Posted by beautox on March 10, 2016 at 18:41:43:

For power cords: Audio gear has power supplies, typically with transformers, rectifiers and capacitors (and sometimes, regulators).

You can't just apply ohms law to work out the instantaneous current for several reasons.

1) The power supply takes current in small bites. Sometimes current is only flowing for a small percentage of the cycle. This is because of the caps and rectifiers - the rectifiers only conduct when the voltage from the transformer is higher than the voltage in the reservoir caps.

2) Usually the power supply will present a complex load, ie it's inductive. So current and voltage are not in phase. Leading to ..

3) Power factor. (look it up..)

For speaker cables : speakers are also typically complex - inductive (unless they are capacitative ;). But also a speaker has moving mass, and for example, when you get a pulse (or the music stops suddenly) the speaker keeps moving and acts as a generator, pushing current back into the amp. And if the amp has a very low output impedance, you have a generator looking into almost a short circuit, so you can get pretty high instantaneous currents.

Long and short of it - ohms law doesn't apply here either.

This is basic electronics, nothing controversial.
https://en.wikipedia.org/wiki/Electrical_characteristics_of_dynamic_loudspeakers