Isolation Ward

From ebony pucks to magic foil, mystical and controversial tweaks.

Use this form to submit comments directly to the Asylum moderators for this forum. We're particularly interested in truly outstanding posts that might be added to our FAQs.
You may also use this form to provide feedback or to call attention to messages that may be in violation of our content rules.

You must login to use this feature.

Inmate Login

By default, logging in will set a session cookie that disappears when you close your browser. Clicking on the 'Remember my Moniker & Password' below will cause a permanent 'Login Cookie' to be set.

Moniker/Username: The Name that you picked or by default, your email. Forgot Moniker?	Examples "Rapper", "Bob W", "joe@aol.com".
Password:	Forgot Password?
	Remember my Moniker & Password ( What's this?)

If you don't have an Asylum Account, you can create one by clicking Here.

Our privacy policy can be reviewed by clicking Here.

Inmate Comments

From:
Your Email:
Subject:

Message Comments

Original Message

RE: I have been paying to know what I think

Posted by Jeff Starr on May 26, 2016 at 11:21:10:
Not sure what BGT is?

I wouldn't think direct connections and isolation would change volume, unless you bypassed actual components along the way. Was there a crossover before? If so, maybe you should consider upgrading the caps, resistors, etc and put it back in the line.

Two other options would be replace volume control with one that would give you more control, or install a resistor in front or after volume control.
There are people here [maybe better to post in the diy Tweaker Asylum] if given specs on current volume control, they can recommend what size, type, and brand of resistors you would need. Also the best place to put them.
Tuning dots won't give you any more control over the volume. Room accoustics should be addressed as a part of optimizing any decent system. But I believe it is a separate project, in this case.