|
High Efficiency Speaker Asylum Need speakers that can rock with just one watt? You found da place. |
For Sale Ads |
Use this form to submit comments directly to the Asylum moderators for this forum. We're particularly interested in truly outstanding posts that might be added to our FAQs.You may also use this form to provide feedback or to call attention to messages that may be in violation of our content rules.
Original Message
RE: Compression driver to horn gasket?
Posted by moray james on May 16, 2017 at 12:28:34:
without the gasket they is likely going to be a gap or at best a poor transition. The gasket is there to make a seal between the driver and the horn. Don't over tighten there should only be enough pressure to make for a snug fit. If you over tighten the gasket will bulge and distort the flair rate which should ideally be continuous from the driver to horn. Look also that the id of the gasket is the same as the od or exit of the driver which should also match the id of the horn throat. Happy trails.