General Asylum

General audio topics that don't fit into specific categories.

Use this form to submit comments directly to the Asylum moderators for this forum. We're particularly interested in truly outstanding posts that might be added to our FAQs.
You may also use this form to provide feedback or to call attention to messages that may be in violation of our content rules.

You must login to use this feature.

Inmate Login

By default, logging in will set a session cookie that disappears when you close your browser. Clicking on the 'Remember my Moniker & Password' below will cause a permanent 'Login Cookie' to be set.

Moniker/Username: The Name that you picked or by default, your email. Forgot Moniker?	Examples "Rapper", "Bob W", "joe@aol.com".
Password:	Forgot Password?
	Remember my Moniker & Password ( What's this?)

If you don't have an Asylum Account, you can create one by clicking Here.

Our privacy policy can be reviewed by clicking Here.

Inmate Comments

From:
Your Email:
Subject:

Message Comments

Original Message

I am not a tube guy!

Posted by 13th Duke of Wymbourne on July 31, 2018 at 17:57:24:
All active devices have a non-linear transfer characteristic from Vin to Iout - for tubes and FETs this the predominantly square law and for bipolar transistors (BJTs) it is predominantly exponential. This is the primary cause of distortion.

For transistors, the change in transfer characteristic caused by changing the voltage across the device (drain-source or collector-emitter) is modeled by a term called the Early Voltage that acts as a resistor in parallel to the transistor and defines its inherent output resistance. But, this is a linear effect so does not contribute to distortion. The linearity of the output followers in my hypothetical amplifier example will not change as the supply voltage goes from +/-30V to +/60V. There could be second order effects if that change mandated picking different transistors to handle the additional voltage. Higher voltage handling FETs will have lower transconductance and higher voltage BJTs will likely have lower current gain that could increase distortion but, again, this would be a second or third order effect.

I am not a tube guy but I would expect them to behave in a broadly similar way (though I don't think anyone makes a tube power amp with cathode follower outputs). Maybe the tube equivalent of the early voltage is a non-linear effect?

Regards
13DoW