VK Music - Elekit & Triode Japan Forum

Welcome! Need support, you got it. Or share your ideas and experiences.

Use this form to submit comments directly to the Asylum moderators for this forum. We're particularly interested in truly outstanding posts that might be added to our FAQs.
You may also use this form to provide feedback or to call attention to messages that may be in violation of our content rules.

You must login to use this feature.

Inmate Login

By default, logging in will set a session cookie that disappears when you close your browser. Clicking on the 'Remember my Moniker & Password' below will cause a permanent 'Login Cookie' to be set.

Moniker/Username: The Name that you picked or by default, your email. Forgot Moniker?	Examples "Rapper", "Bob W", "joe@aol.com".
Password:	Forgot Password?
	Remember my Moniker & Password ( What's this?)

If you don't have an Asylum Account, you can create one by clicking Here.

Our privacy policy can be reviewed by clicking Here.

Inmate Comments

From:
Your Email:
Subject:

Message Comments

Original Message

RE: So...

Posted by vkung on February 20, 2017 at 09:25:50:
Can't you or won't you answer my questions?
I did answer your QUESTIONS
I only recommend to upgrade 4 coupling caps (AMCO 0.1 X 4) and 4 cathode by pass caps (Sanyo OS-CON 180uf 16V). We tested our suggestion. It mentioned in THE MANUAL. YOU WANT TO USE 220uF. IT is your choice.

The link shows that there is a 220uf, 16V OS-CON. Why would you not recommend these capacitors (of any value, 180uf, 220uf, etc) for the output tubes after recommending them for the 12AU7 tubes? please refer to question 1
You say 220uf, 16V is too much capacitance for the output tube. Then why are 220uf, 16V capacitors included in the basic kit and a range of 150uf - 220uf is recommended in the instructions? If 220uf is too big, what value would your recommend for the outputs?
IT IS THE SIZE NOT THE CAPACITANCE. I only recommend to replace these 4 coupling caps and 4 cathode by pass cap.