DIY HiFi Forum

Welcome! Need support, you got it. Or share your ideas and experiences.

Use this form to submit comments directly to the Asylum moderators for this forum. We're particularly interested in truly outstanding posts that might be added to our FAQs.
You may also use this form to provide feedback or to call attention to messages that may be in violation of our content rules.

You must login to use this feature.

Inmate Login

By default, logging in will set a session cookie that disappears when you close your browser. Clicking on the 'Remember my Moniker & Password' below will cause a permanent 'Login Cookie' to be set.

Moniker/Username: The Name that you picked or by default, your email. Forgot Moniker?	Examples "Rapper", "Bob W", "joe@aol.com".
Password:	Forgot Password?
	Remember my Moniker & Password ( What's this?)

If you don't have an Asylum Account, you can create one by clicking Here.

Our privacy policy can be reviewed by clicking Here.

Inmate Comments

From:
Your Email:
Subject:

Message Comments

Original Message

DAC Output Stage - order placed!

Posted by Mikey on December 31, 2009 at 08:13:26:
Hi Brian,

I ordered the kit today, I decided on (1) UTS.
It was going to be tough to shoehorn two of those modules in there anyway... :-)

The only thing to clarify is the wiring between the DAC chip and the module, let's see if I've got this close:

DAC pin 26 (L-) to UTS terminal 'in L'
DAC pin 25 (L+) to 22 ohm resistor, resistor to GND
DAC pin 18 (R-) to UTS terminal 'in R'
DAC pin 17 (R+) to 22 ohm resistor, resistor to GND

In the Denon schematic, all four AGND pins (16, 19, 24, 27) are tied together....this will be my analog ground, correct?
If correct, let's call this GND.

GND to UTS terminal 'Gnd L'
GND to UTS terminal 'Gnd R'
GND to UTS terminal 'Vcom L'
GND to UTS terminal 'Vcom R'

So far so good?

The schematic on page 22 of the manual shows (4) 51 ohm resistors.
What do I do about those?

I could locate the 22 ohm resistors close to the DAC chip, or I could mount them somewhere on the UTS....which is preferred?

Thanks,

Mike