Cable Asylum

Interconnects, speaker wire, power cords. Ask the Cable Guys.

Use this form to submit comments directly to the Asylum moderators for this forum. We're particularly interested in truly outstanding posts that might be added to our FAQs.
You may also use this form to provide feedback or to call attention to messages that may be in violation of our content rules.

You must login to use this feature.

Inmate Login

By default, logging in will set a session cookie that disappears when you close your browser. Clicking on the 'Remember my Moniker & Password' below will cause a permanent 'Login Cookie' to be set.

Moniker/Username: The Name that you picked or by default, your email. Forgot Moniker?	Examples "Rapper", "Bob W", "joe@aol.com".
Password:	Forgot Password?
	Remember my Moniker & Password ( What's this?)

If you don't have an Asylum Account, you can create one by clicking Here.

Our privacy policy can be reviewed by clicking Here.

Inmate Comments

From:
Your Email:
Subject:

Message Comments

Original Message

RE: Check these out

Posted by mitch2 on December 29, 2016 at 11:43:56:
I stumbled across them because I was looking for spades that would accept a huge wire size for a DIY cable I was trying out, and they sell them.
I ended up buying spades and a bunch of the bananas because they were so inexpensive.
I still like my Furutech spades best, and I mostly use the Furez bananas for my HT set-up, but I do have the bananas you are looking at. They fit my amp's WBT posts very snug. I suspect you will be satisfied. My only (minor) issue is the T6 torx size they use is quite small and susceptible to stripping - I purchased a few extra of the small screws. If you are careful and tighten incrementally it should be fine. They will even sell you a torx driver (screwdriver type) for just over $3 that fits their torx stuff.