Amp/Preamp Asylum

Looking for a new Amp or Preamp? If you're after tubes, post over here.

Use this form to submit comments directly to the Asylum moderators for this forum. We're particularly interested in truly outstanding posts that might be added to our FAQs.
You may also use this form to provide feedback or to call attention to messages that may be in violation of our content rules.

You must login to use this feature.

Inmate Login

By default, logging in will set a session cookie that disappears when you close your browser. Clicking on the 'Remember my Moniker & Password' below will cause a permanent 'Login Cookie' to be set.

Moniker/Username: The Name that you picked or by default, your email. Forgot Moniker?	Examples "Rapper", "Bob W", "joe@aol.com".
Password:	Forgot Password?
	Remember my Moniker & Password ( What's this?)

If you don't have an Asylum Account, you can create one by clicking Here.

Our privacy policy can be reviewed by clicking Here.

Inmate Comments

From:
Your Email:
Subject:

Message Comments

Original Message

RE: Awesome

Posted by wood1 on April 12, 2017 at 17:48:09:
Ok here we go. I spoke with Bob today. The problem in the low voltage power supply is fixed. He has identified the left channel gain issue as a
faulty interstage film cap. I gave him the ok to fix these as well as
installing an additional pair of input rca's into the case for #1 input. The
glaring weak link (imho) in the design is that all the rca's are soldered directly
to the rear of the PCB which protrudes out of the back of the case. The
issue is that I now use High Fidelity Cables interconnects that are
extremely tight so you are playing with fire when connecting or removing.
He is also going to replace the suspect resistors that he has identified.

Again my plan is to get this home to run in for a while and then
put it up against his Rhumba 1.2 and see what is what. I will keep you guys posted.

Happy listening