|
Vinyl Asylum Welcome Licorice Pizza (LP) lovers! Setup guides and Vinyl FAQ. |
|
|
|
Vinyl Asylum Welcome Licorice Pizza (LP) lovers! Setup guides and Vinyl FAQ. |
|
In Reply to: RE: Help on TT upgrade posted by NoTechnics on November 9, 2011 at 11:48:23:
>>Virtually any table with a platter that sits on the motor is going to be a weak point. The motor vibration gets transferred to the stylus.<<
Not "any" DD table, some of the better DD's sound quite transparent. And this isn't just a problem with DD, if the belt driven motor vibrates, unless that noise is isolated (very difficult) it will be transferred to the platter/stylus.
The fact is, early Rega's had very noisy motors, and the cheap "rubber" band isolation didn't help much to isolate it from the stylus. A shame, considering the main bearing was well designed.
TB1
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Not just a direct drive issue ... - TBone 12:24:18 11/09/11 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
