|
Vinyl Asylum Welcome Licorice Pizza (LP) lovers! Setup guides and Vinyl FAQ. |
|
|
|
Vinyl Asylum Welcome Licorice Pizza (LP) lovers! Setup guides and Vinyl FAQ. |
|
In Reply to: RE: Mine turned into a parallelogram when pushed from the end . . . posted by learsfool on October 13, 2009 at 08:39:36:
I actually used corner braces which are marginal. I wish that I had used two sheets of plywood cut to fit and painted the same color as the shelves.
You will find that, unless up close to a rear wall, that it is nice to have stop blocks at the back of each cubicle. This keeps the records from pushing through. I used small wood strips, but a sheet of plywood at the back would have solved both problems. It would also have taken less time.
From experience, I believe that you can exceed the weight limit with no problems at all. The Expedit shelf unit is super strong in the vertical, and you can fill each cubicle with records. The only weakness is in the horizontal plane.
You can see my front picture in the link at the very bottom of this thread, and you will see no sagging at all. Bill.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Is he going to notch the point where the two 1 X 4s cross? - hiatt@alaska.net 09:35:18 10/13/09 (2)
- RE: Is he going to notch the point where the two 1 X 4s cross? - learsfool 12:35:25 10/13/09 (1)
- The unit did not come with corner braces, and thanks - hiatt@alaska.net 16:51:53 10/13/09 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
