Isn't specifying the table to indicate spindle diameter?

Vinyl Asylum

Welcome Licorice Pizza (LP) lovers! Setup guides and Vinyl FAQ.

Follow Ups Full Thread

Topic - Ramblings concerning the MintLP Protractor - very impressed and some suprising results... - VynylTap 12:05:19 03/01/09 (20)

RE: Ramblings concerning the MintLP Protractor - very impressed and some suprising results... - MarkD 13:07:30 03/02/09 (1)

Just to be clear - I've never used Ken's protractor, but it's well liked here... - VynylTap 14:32:46 03/02/09 (0)

Better LIke It, It's Expensive - Fishstink 08:43:31 03/02/09 (1)

Give me a break.... - VynylTap 08:47:32 03/02/09 (0)

Is the MintLP protractor table-specific, or table-arm combo specific? [nt] - travisty 02:57:51 03/02/09 (3)

That's my understanding of it... - VynylTap 08:55:16 03/02/09 (2)

Isn't specifying the table to indicate spindle diameter? - Jeff Maxson 09:08:00 03/02/09 (1)

That's the only thing that makes sense... - VynylTap 09:55:24 03/02/09 (0)

It would be interesting to hear before and after recordings. - Bry 14:34:23 03/01/09 (3)

I still have to get my self in gear and try your design. )MT( - J. S. Bach 17:20:57 03/01/09 (0)

I may actually be able to do that - let me dig around in my recordings... - VynylTap 14:46:33 03/01/09 (1)

I think it's a valuable tool. - Bry 05:29:37 03/02/09 (0)

RE: Ramblings concerning the MintLP Protractor - very impressed and some suprising results... - JayTea 13:03:28 03/01/09 (7)

RE: Ramblings concerning the MintLP Protractor - very impressed and some suprising results... - FolkFreak 13:49:06 03/01/09 (0)

I have no idea!!!! - VynylTap 13:40:09 03/01/09 (5)

RE: I have no idea!!!! - JayTea 13:48:42 03/01/09 (4)

On the Technics SL-1200, yes... - VynylTap 14:04:09 03/01/09 (3)

RE: On the Technics SL-1200, yes... - sberger 09:38:56 03/02/09 (2)

RE: On the Technics SL-1200, yes... - JayTea 03:06:07 03/04/09 (0)

It's much more precise than any paper protractor I've ever used... - VynylTap 14:19:10 03/02/09 (0)

Follow Ups

Isn't specifying the table to indicate spindle diameter? - Jeff Maxson 09:08:00 03/02/09 (1)

That's the only thing that makes sense... - VynylTap 09:55:24 03/02/09 (0)

Post a Message!