RE: Ayre DPS turntable - Comments by Hansen/Silberman

Posted by restock (A) on January 28, 2008 at 08:54:05

In Reply to: RE: Ayre DPS turntable - Comments by Hansen/Silberman posted by berlinta on January 28, 2008 at 04:56:45:

Frank,

thanks very much for the correction -I think it was somewhere else on asylum that I read about your alleged involvement in the bearing design. Thanks very much for giving due where it belongs (i.e. to Willi).

Nice explanation of the friction bearing. Most designers use high mass designs to increasing the moment of inertia and thus lessen the effect of stylus drag. I agree that introducing additional drag coupled with a high torque motor is an elegant solution to achieve a similar effect (thus simulating a high mass design) without any of the negative effect of high mass platters. And it shows sonically :)

Cheers,

Rene

Die gefÃ¤hrlichste Weltanschauung ist die Weltanschauung derjenigen, die die Welt nicht angeschaut haben.
Alexander von Humboldt (1769-1859)

This post is made possible by the generous support of people like you and our sponsors:

Follow Ups Full Thread

Topic - Ayre DPS turntable - Comments by Hansen/Silberman - restock 21:24:58 01/27/08 (12)

RE: Ayre DPS turntable - Comments by Hansen/Silberman - Davy-pie 13:32:39 01/29/08 (0)

RE: Ayre DPS turntable - Comments by Hansen/Silberman - restock 13:48:29 02/01/08 (0)

A clarification from Hansen - Charles Hansen 10:21:43 01/28/08 (4)

Thank you for the thorough clarification! - restock 12:00:21 01/28/08 (2)

RE: could not find your contact information or and email address for Ayre - Charles Hansen 20:27:19 01/28/08 (1)

RE: could not find your contact information or and email address for Ayre - ejlif 21:19:42 01/28/08 (0)

RE: could not find your contact information or and email address for Ayre - Charles Hansen 19:43:14 01/29/08 (0)

A clarification, indeed! Which is just what is needed to... - Neil49 10:43:41 01/28/08 (0)

RE: Ayre DPS turntable - Comments by Hansen/Silberman - berlinta 04:56:45 01/28/08 (3)

High friction bearing for low mass table- sounds nuts to me. - jsm 18:04:19 01/28/08 (1)

RE: High friction bearing for low mass table- sounds nuts to me. - berlinta 02:28:07 01/29/08 (0)

RE: Ayre DPS turntable - Comments by Hansen/Silberman - restock 08:54:05 01/28/08 (0)

RE: Ayre DPS turntable - Comments by Hansen/Silberman - DevilDawgMom 21:37:42 01/27/08 (1)

Thanks!! - restock 21:52:51 01/27/08 (0)

Follow Ups

RE: Ayre DPS turntable - Comments by Hansen/Silberman - restock 08:54:05 01/28/08 (0)

RE: Ayre DPS turntable - Comments by Hansen/Silberman

Post a Message!