RE: maybe something like this?

Posted by troporobo (A) on September 24, 2007 at 08:29:47

In Reply to: RE: maybe something like this? posted by KWILLIS on September 24, 2007 at 06:22:12:

No worries, hope it works out for you. Since you have to eyeball the alignment, it is a lot easier to punch the larger diameter first, then the inner hole. If you do it the other way around you'll often be off center, unless the punches are sharp enough to first scribe an outline on the sorbothane

This post is made possible by the generous support of people like you and our sponsors:

Follow Ups Full Thread

Topic - Any ideas on how to punch 1/4" to 3/8" discs out of 1/8" thick sorbothane? - KWILLIS 04:50:59 09/24/07 (14)

Why bother? - Abel McCain 18:47:32 09/25/07 (0)

Old modeling technique.. - Scottrt 03:48:31 09/25/07 (1)

I like yours the best - beach cruiser 14:19:10 09/25/07 (0)

RE: Any ideas on how to punch 1/4" to 3/8" discs out of 1/8" thick sorbothane? - l1945@sbcglobal.net 11:31:56 09/24/07 (0)

a set of cork borers - mhardy6647 09:32:29 09/24/07 (0)

maybe something like this? - troporobo 05:54:24 09/24/07 (5)

RE: maybe something like this? - KWILLIS 06:22:12 09/24/07 (2)

I think I purchased my hole punch kit at a leather goods store. nt - hiatt@alaska.net 09:25:56 09/24/07 (0)

RE: maybe something like this? - troporobo 08:29:47 09/24/07 (0)

dontcha just LOVE harbor freight? - hifitommy 06:00:43 09/24/07 (1)

I thought you were able to find that 750 horsepower vacuum! - Muzikmike 07:06:34 09/24/07 (0)

RE: Any ideas on how to punch 1/4" to 3/8" discs out of 1/8" thick sorbothane? - JoeLip 05:48:16 09/24/07 (2)

guard your fingers (always cut away from them, not towards) - Muzikmike 07:19:39 09/24/07 (1)

RE: guard your fingers (always cut away from them, not towards) - JoeLip 09:25:59 09/24/07 (0)

Follow Ups

RE: maybe something like this? - troporobo 08:29:47 09/24/07 (0)

RE: maybe something like this?

Post a Message!