|
Vinyl Asylum Welcome Licorice Pizza (LP) lovers! Setup guides and Vinyl FAQ. |
|
|
|
Vinyl Asylum Welcome Licorice Pizza (LP) lovers! Setup guides and Vinyl FAQ. |
|
In Reply to: Re: Cartridge allignment nightmares...HERE WE GO AGAIN! posted by Munkie_NL on May 17, 2007 at 11:36:53:
The overhang gauge is way off compared to a BAERWALD protractor, which is what the HFNRR is. That's because the table wasn't designed with those null points. The overhang gauge is supposed to set a distance of 49mm from the end of the rubber washer to the stylus tip, with the cartridge parallel to the headshell. Pioneer used that measurement for virtually all of its S-arms, and the resulting offset angle determines its null points. You don't have to use that, but I certainly find it easier and faster to do it that way, and that was what Pioneer used when it designed the turntable.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Re: Cartridge allignment nightmares...HERE WE GO AGAIN! - Howard K 11:51:46 05/17/07 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
