Vinyl Asylum Welcome Licorice Pizza (LP) lovers! Setup guides and Vinyl FAQ. |
|
In Reply to: you are too kind, and you're very welcome posted by dean man jim on May 6, 2007 at 16:51:47:
Hi dean man jim,
I've been thinking of doing something similar with my Russco. My question is, how did you cut the armboard to sit so low in the table? I'm assuming you used a router or something similar to notch the edge so the board would sit at close to the same level as the Russco armboard that came off of it? Can I find that wood at a local hardware store or do I need to go to a specialty store?
Thanks,
Ken
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Question about cutting that armboard - KWILLIS 04:12:59 05/07/07 (1)
- Re: Question about cutting that armboard - dean man jim 04:50:41 05/07/07 (0)