Vinyl Asylum Welcome Licorice Pizza (LP) lovers! Setup guides and Vinyl FAQ. |
|
In Reply to: RE: Michell Gyro Bearing Blues posted by Triode Junky on May 2, 2007 at 13:41:08:
Hi All,Many thanks for the insights. Previous to my original posting, I did as suggested, clean the bearing and replace the oil and ballbearing. The bearing housing (bronze) is approx. 2mm clear of the sub- chassis. I suspect the the bearing was duff from the beginning.
I shall ring Michell. I'm wondering whether the coned area inside the bearing housing where the steel ball sits,
isn't hundred percent, hence the attendent noise...Regards,
T.J.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Re: RE: Michell Gyro Bearing Blues - Triode Junky 03:32:31 05/06/07 (0)