Vinyl Asylum Welcome Licorice Pizza (LP) lovers! Setup guides and Vinyl FAQ. |
|
Hi All,Its been a while since I'd used my Gyro (Gyro SE, D.C. motor circa 2001), I'd previously been using a Technics SL10 (it's a real dream to use). Anyhoo, I fired it up (I had packed it away in its original packaging and so had to re-build it), and when I happened to put my ear reaaal close to the spindle, I could hear a light scraping sound. No worries, I'll ring Michell, get a new ball bearing, everything should be fine and dandy...
Wrong! The noise was still there. Maybe the noise was always there and I just hadn't noticed. Maybe in the intervening months I've turned terribly anal..
Well, Guys, I'm hoping for some perceptive rational explanation and quick fix. Advice welcome from all.
Regards,
T.J.
This post is made possible by the generous support of people like you and our sponsors:
Topic - RE: Michell Gyro Bearing Blues - Triode Junky 13:41:08 05/02/07 (10)
- Re: RE: Michell Gyro Bearing Blues - Triode Junky 03:32:31 05/06/07 (0)
- Re: RE: Michell Gyro Bearing Blues - MAS 17:16:57 05/03/07 (0)
- Re: RE: Michell Gyro Bearing Blues - Fretless 13:56:47 05/02/07 (7)
- Agreed.... - damage k 14:15:49 05/02/07 (6)
- Re: Agreed.... - FrankC 15:26:08 05/02/07 (5)
- Re: Agreed.... - Ronnie.S 11:49:07 05/03/07 (3)
- Thanks for the info! - FrankC 13:34:24 05/03/07 (2)
- Keep us posted.... - damage k 15:10:30 05/03/07 (0)
- Correction: Silicon Nitride ball bearing. (nt) - FrankC 13:41:10 05/03/07 (0)
- If you're in the US try contacting Artech... - lenzkap 16:59:00 05/02/07 (0)