Vinyl Asylum Welcome Licorice Pizza (LP) lovers! Setup guides and Vinyl FAQ. |
|
In Reply to: How to measure tonearm mounting distance? posted by David Lawrence on April 27, 2007 at 21:36:14:
First, pull out the platter. Now you have the main bearing at the same plane as the tonearm mounting hole. I like to use a sturdy wire and measure out 222 mm. Mark the point and you are ready to drill.Make sure these measurements are from the center of the main well to center of the 222 mm tonearm hole.
On My B12GH the 222 mm tonearm hole ended up occupying the very far corner of the turntable platten.
Make sure you get this level as well as properly distanced.I hope this helps.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Simple as can be.....here goes.... - tubesforever 00:37:46 04/28/07 (0)