Vinyl Asylum Welcome Licorice Pizza (LP) lovers! Setup guides and Vinyl FAQ. |
|
In Reply to: Wait until you hear a Rek O Kut ..... posted by tubesforever on April 27, 2007 at 09:40:16:
I've been meaning to take your advice on this subject, but I've been busy building those speakers I mentioned earlier. by the way, I replied to you with a couple questions down the way a bit on that thread. I don't mean to be pushy, I just wasnt' sure if you were planning to revisit that particular thread so I mention it here. I'd appreciate your thoughts on that.Back to the subject at hand:
Where do you get the silicone nitride ball? How much?
I think you just answered my other question, but I guess when you say micropolish the bearing, you are refering to the shaft attached to the platter? Or are you refering to the bearing well, or both? I appreciate your suggestion to send you the platter, but I would prefer to do it locally if possible. You mentioned before to give it to a machine shop I think. Will just any old machine shop do or is there a place in particular you use? I don't really know where to begin with that and how do you communicate to them what you want? I suspect they get relatively few requests for vintage table bearing micropolishing.
Thanks for your thoughts on this!!!
Nate
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- I've been meaning to ping you on this subject - texanater 10:01:18 04/27/07 (4)
- or go to Boca Bearing - MikeWI 12:39:38 04/27/07 (1)
- which bearing do you prefer?... - texanater 07:06:13 04/28/07 (0)
- Go to McMaster.com in their search box type silicone nitride ball. - tubesforever 10:53:14 04/27/07 (1)
- Thanks! nt - texanater 13:46:07 04/27/07 (0)