Vinyl Asylum Welcome Licorice Pizza (LP) lovers! Setup guides and Vinyl FAQ. |
|
In Reply to: Re: Seeking loading recommendations on Benz Ace Medium...(Risabet..are you listening?) posted by risabet on April 25, 2007 at 14:02:28:
Hello Risabert-I have a question I hope you can answer. I have a Denon DL 102 with a recommended load of 1K ohms or more, according to the literature that came with the cart. Its output is 3.0 mv, so I am putting it in directly to my Hagerman Cornet, with the standard 47K ohms. What value resistors would I use in your type of "Y" connector set-up to arrive at 1K ohms? What effect might this lower value have on the sound?
I appreciate your help.
Best,
Dan
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Seeking loading recommendations to acheive 1K Ohms - fishy 17:28:05 04/25/07 (2)
- Re: Seeking loading recommendations to acheive 1K Ohms - risabet 19:42:40 04/25/07 (0)
- not risabet but, a 1k ohm resistor - OMalley 18:09:59 04/25/07 (0)