|
Vinyl Asylum Welcome Licorice Pizza (LP) lovers! Setup guides and Vinyl FAQ. |
|
|
|
Vinyl Asylum Welcome Licorice Pizza (LP) lovers! Setup guides and Vinyl FAQ. |
|
In Reply to: Re: Nottingham Horizon Help! posted by markinuk on April 18, 2007 at 11:34:35:
Hi Mark,Thanks for your suggestions. I tried the opposite approach and tightend the collar and base screws. I will loosen them.
This is the non-SE version. I will check to see if I can adjust the motor height when I get home but most of the motor is submerged in the plinth. Finally, I will add even more bearing oil. Apparently it wasn't drained when it was shipped. Nonetheless, I added 12 drops. I will add more til it leaks...this might do the trick as the vibration only occurs when the platter is spinning, and actually about 3 seconds after it spins.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Re: Nottingham Horizon Help! - Tsloan 13:32:31 04/18/07 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
