Vinyl Asylum Welcome Licorice Pizza (LP) lovers! Setup guides and Vinyl FAQ. |
|
In Reply to: What's the mass of the Syntec arm? The AT works best with posted by HenryH on April 17, 2007 at 15:52:45:
The manual doesn't say, Henry. But it does say it's a "light alloy arm with low mass headshell." The headshell I have on it is a Technics headshell, but I think the arm is a relatively low to med mass arm.The S220 was also marketed under the name Japan Piezo PU402, again TA mass spec given in the manual, but the recommended cart for it was spec'd at wt=5g, compliance=5x10-6cm/dyne, which is low compliance cart, right? Same as the DL103 stat? Hmmm...
Thanks,
Jim
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Re: What's the mass of the Syntec arm? The AT works best with - jazzthusiast 17:07:18 04/17/07 (1)
- Yep. Sounds like the arm is relatively high mass. Definitely - HenryH 18:27:16 04/17/07 (0)