|
Vinyl Asylum Welcome Licorice Pizza (LP) lovers! Setup guides and Vinyl FAQ. |
|
|
|
Vinyl Asylum Welcome Licorice Pizza (LP) lovers! Setup guides and Vinyl FAQ. |
|
In Reply to: Would you recommend it for a table with a ceramic or teflon bearing? (nt) posted by clio09 on April 17, 2007 at 12:11:07:
If the entire bearing is ceramic (the shaft and the bearing wall), I would not recommend it. If the shaft and housing are metal but use a teflon or ceramic thrust pad at the bottom (or top, if it's an inverted bearing,) that would be OK.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Re: Would you recommend it for a table with a ceramic or teflon bearing? (nt) - nsgarch 12:48:30 04/17/07 (3)
- Re: Would you recommend it for a table with a ceramic or teflon bearing? (nt) - clio09 15:11:19 04/17/07 (2)
- Re: Would you recommend it for a table with a ceramic or teflon bearing? (nt) - nsgarch 15:44:26 04/17/07 (1)
- Thanks, I'll look into it... - clio09 18:43:31 04/17/07 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
