Vinyl Asylum Welcome Licorice Pizza (LP) lovers! Setup guides and Vinyl FAQ. |
|
In Reply to: Re: Recommendations for Cartridge Lead wires? posted by anumber1 on April 15, 2007 at 08:06:18:
With the second set of leads I used locking hemostats (one click only) attached to the solder tab directly behind the female end of the clip. The tab part of the clip easily tore away with very little pressure.With the leads that came with the PT-9 arm I used my fingers and take some, if not most, of the blame. With these I can only say that any of the solder joints I make would have never separated like these did; they appear to have been cold joints.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- locking hemostats - tonyb_2k 08:19:35 04/15/07 (1)