Vinyl Asylum Welcome Licorice Pizza (LP) lovers! Setup guides and Vinyl FAQ. |
|
In Reply to: When fitting a platter to a tapered shaft, like on a Garrard posted by ffrr on April 14, 2007 at 18:33:14:
You could put on a little antiseize which is typically used in motors for dissimilar metals so there will be no eletrolysis and welding of the two materials. This is basically a light grease mixed with graphite powder.A poster below recommends nothing and I agree. Only use the antiseize if you know your environment is going to cause you problems down the road.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- If you are in a high humidity or high salt environment - tubesforever 20:54:32 04/14/07 (0)