|
Vinyl Asylum Welcome Licorice Pizza (LP) lovers! Setup guides and Vinyl FAQ. |
|
|
|
Vinyl Asylum Welcome Licorice Pizza (LP) lovers! Setup guides and Vinyl FAQ. |
|
In Reply to: Good suggestions. Is this also doable? posted by tonyptony on September 17, 2006 at 14:11:55:
I don't believe so. Alcohol and oil do not mix. You need to cut through any dried residue that might be there, so a stronger solvent would do a better job. Lighter fluid, electric motor cleaner, and brake cleaner are some choices. Cleaning with boiling propane, as has been suggested by Mark Kelly, will get into the pores of sintered bronze, if perfect is your goal. WD-40 will coat the surface, and that is not necessarily what you want. In any case, it would be a good idea to have the bearing assembly out of the turntable and in a well ventilated space.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Re: Good suggestions. Is this also doable? - mosin 14:18:14 09/17/06 (10)
- I recently tried electric motor cleaner and it worked - richardl 11:00:20 09/18/06 (0)
- Ronsonal - InDaGroove 18:47:02 09/17/06 (6)
- Re: Ronsonal - tonyptony 19:49:18 09/17/06 (4)
- Re: Ronsonal - InDaGroove 20:31:36 09/17/06 (3)
- Naptha - J.D. 22:43:03 09/17/06 (2)
- Re: Naptha - tonyptony 05:08:58 09/20/06 (0)
- Naptha? - mosin 11:06:17 09/18/06 (0)
- Re: Ronsonal - mosin 19:22:37 09/17/06 (0)
- Re: Good suggestions. Is this also doable? - tonyptony 16:14:08 09/17/06 (1)
- Re: Good suggestions. Is this also doable? - mosin 16:21:06 09/17/06 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
