|
Vinyl Asylum Welcome Licorice Pizza (LP) lovers! Setup guides and Vinyl FAQ. |
|
|
|
Vinyl Asylum Welcome Licorice Pizza (LP) lovers! Setup guides and Vinyl FAQ. |
|
In Reply to: Tonearm for Kenwood KD-500 'table posted by scotbuck on September 16, 2006 at 22:17:08:
I recommend a Linn Basic (straight tonearm) for your table. They make a good match. You will have to be diligent in finding one with good bearings, but they are worth it.You may also want to experiment with different mats (I like cork on this table), and use a Michell clamp.
Replace the capacitors in the motor's control circuit if you detect any speed variations that you cannot otherwise rectify.
The Ortofon OM-series is decent, but maybe a bit to analytical for this table. I have nontheless had good results using an OM-20 with the above mentioned tweaks.
But ultimately, I would prefer something a bit warmer while retaining the OM's overall balance.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Re: Tonearm for Kenwood KD-500 'table - George Mann 23:36:48 09/16/06 (2)
- Re: Tonearm for Kenwood KD-500 'table - scotbuck 06:43:11 09/17/06 (1)
- Re: Tonearm for Kenwood KD-500 'table - George Mann 07:40:01 09/17/06 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
