Your DL-S1 is likely riding in a lower part of the groove where

Vinyl Asylum

Welcome Licorice Pizza (LP) lovers! Setup guides and Vinyl FAQ.

In Reply to: What contributes to surface noise the most (or, my DL103 replacement is driving me mad)? posted by Doug Flynn on September 15, 2006 at 01:07:35:

your DL-1-3 with its larger conical tip could not reach. The DL-S1's eliptical stylus is on the small side, 0.07 x 0.14mm IIRC, so it gets down in the groove deeper.

Henry
A 12-gauge shotgun is the ultimate arbiter of disputes - G. Gordon Liddy

This post is made possible by the generous support of people like you and our sponsors:

Schiit Audio

Follow Ups Full Thread

Topic - What contributes to surface noise the most (or, my DL103 replacement is driving me mad)? - Doug Flynn 01:07:35 09/15/06 (2)

Its not the cart - cmk 21:38:48 09/15/06 (0)

Your DL-S1 is likely riding in a lower part of the groove where - HenryH 04:03:53 09/15/06 (0)

Follow Ups

Your DL-S1 is likely riding in a lower part of the groove where - HenryH 04:03:53 09/15/06 (0)

You can not post to an archived thread.