Vinyl Asylum Welcome Licorice Pizza (LP) lovers! Setup guides and Vinyl FAQ. |
|
In Reply to: Rega counter weights (again?!) posted by Aleksunder on September 11, 2006 at 06:07:53:
Joking aside, some 'theoretical' explanations are THE joke.Try to calculate change in VTF due to CW c.g. offset for a change in stylus elevation.
Compare that to change in VTF due to acceleration of the arm cartridge assembly while tracking warp.
Than think about whole arm cartidge assembly (less CW) and where the c.g. is.
Than think where the bearing is and how stylus moves as elevation is changed.
Than think about change in relative recod groove speed at the warp and it's effect.
Than think about bearing friction
Than think about wiring friction.
Than think about all of the above.
Than (hopefully) you will see why I consider explanation a joke.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- If you assume you make ..... - Stale 10:58:16 09/11/06 (4)
- Re: If you assume you make ..... - Aleksunder 12:15:41 09/11/06 (3)
- Re: If you assume you make ..... - Stale 15:13:31 09/11/06 (1)
- I both agree and disagree with you....yes I am conflicted.... - tubesforever 00:18:11 09/12/06 (0)
- Re Imeant " about 1.8HZ up", not 33.3 HZ. n/t - Aleksunder 12:37:37 09/11/06 (0)