Vinyl Asylum Welcome Licorice Pizza (LP) lovers! Setup guides and Vinyl FAQ. |
|
In Reply to: MC Gain posted by rontokyo on September 8, 2006 at 01:47:58:
on the 50dB setting the output to your line preamp will be:592mV
That is kinda high but not too bad, I don't think there will be an overload situation.
I also saw there is a 200ohm setting. Don't laugh but you should try that too. I use my DL-103 as less than the 40ohm DC resistance.
At 200ohm the total output to the linestage will be:
430mV
You may actually like the control and speed with a low load impedance- It can't hurt to try, it's only a flick of a switch, no?
Good luck.
Please report back if you try these settings, I think you may be surprised.
Cheers!
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- I see from the specs 400 ohm is the highest for the MC input which means - Garth 02:13:00 09/08/06 (1)
- Thanks, Garth . . . - rontokyo 02:43:30 09/08/06 (0)