Help Goldring 1042 - SME III - Thorens 125 II tracking too low. - valvesonly

Vinyl Asylum

Welcome Licorice Pizza (LP) lovers! Setup guides and Vinyl FAQ.

Help Goldring 1042 - SME III - Thorens 125 II tracking too low.

Advise & help. The Golding has the bottom lip that can lightly touch the surface when down on even fractional warp.. If I increase VTA the stylus wont even touch the record.
The arm wand really looks to me that it has a fractional up curve near the end (Ebay?) and has been rewired.
Flat sound, not enthralling at all, but I also have a ground hum to get rid of as well contributing to this. (just needs a new wire from TT to phono Pre)
what can I source to make the cartridge lower in headshell without adding much weight so I can play with VTA. Cartridge has no problems on a Linn and Alphason arms

This post is made possible by the generous support of people like you and our sponsors:

Michael Percy Audio

Topic - Help Goldring 1042 - SME III - Thorens 125 II tracking too low. - valvesonly 20:44:17 09/07/06 (0)

You can not post to an archived thread.