![]() |
Vinyl Asylum Welcome Licorice Pizza (LP) lovers! Setup guides and Vinyl FAQ. |
|
In Reply to: Thanks. posted by anumber1 on August 8, 2006 at 17:54:33:
I really thought you might have been making a joke because some others called c-J a troll. I'm really surprised, though, that the Vinyl Engine would allow such nonsense to go unchallenged.As far as antiskating is concerned, it really doesn't matter whether grooves are present or not. A spinning flat surface without grooves will also cause skating force. It just might not cause the same amount of skating force as a grooved surface because the stylus contacts a flat surface at its tip while the sides of stylus contact a groove. Depending on the geometry of the stylus, there will normally be a difference in the frictional force. Of course, if you select a completely different material, such as glass instead of vinyl, then you will definitely have a different frictional force in all respects.
There is really no good way to set antiskating that I have found. Since I have a very expensive tonearm, I use its antiskating gauge as a starting point. I figure SME has done their research; however, every cartridge is slightly different due to stylus geometry and cantilever suspension. Therefore, I tweak by ear when I feel I hear tracking problems on highly dynamic LPs. Recently, I felt the need to reduce antiskating slightly on my DL-103R after hearing some anomalies on a couple of records. I'm tracking my DL-103R at 2.5-grams, but my antiskating is set to about 2.2. So far, it seems to be just about right.
Best regards,
John Elison
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Hey, you're welcome. I didn't mean to be rude.... - John Elison 18:19:20 08/08/06 (9)
- Yes, you score the bull's eye. (long) - cheap-Jack 13:30:46 08/09/06 (1)
- Re: Yes, you score the bull's eye. (long) - John Elison 16:29:15 08/09/06 (0)
- Sort of a way.... - mosin 19:34:55 08/08/06 (6)
- Re: Sort of a way.... - John Elison 19:49:04 08/08/06 (5)
- Well.... - mosin 20:03:47 08/08/06 (4)
- Sorry! ;-) - John Elison 20:13:12 08/08/06 (3)
- Re: Sorry! ;-) - mosin 20:35:00 08/08/06 (2)
- Look at your Kenwood arm... - tubesforever 10:07:20 08/09/06 (1)
- Re: Look at your Kenwood arm... - mosin 15:25:24 08/09/06 (0)