Vinyl Asylum Welcome Licorice Pizza (LP) lovers! Setup guides and Vinyl FAQ. |
|
In Reply to: Re: Setting Cartridge alignment using a Two Point Protractor posted by Mel on February 7, 2001 at 09:25:52:
To set overhang directly, the stylus needs to be placed on a the line through centre of the arm pivot and the platter spindle. Many arms do not allow enough movement to do this.Moreover, for an arm with head-shell slots, to set overhang directly, you need to know the mounting distance (ie distance from platter spindle to centre of arm pivot). This should be measured, and the overhang calculated using the formula below. The manufacturers data is often (usually) unreliable.
Overhang = Sqrt(Lm^2 + N1*N2) - Lm ( ^2 means squared, * means multiplied by)
N1, N2 = inner and outer null radii respectively
Lm = mounting distance.
But you are right, if it is possible to set overhang firstly, it makes things easier, as there is no need to go back and forth between alignment points.
Best regards,
Brian
Brian
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Re: Setting Cartridge alignment using a Two Point Protractor - bkearns 19:14:32 02/07/01 (5)
- Re: Setting Cartridge alignment using a Two Point Protractor - Mel 19:27:12 02/07/01 (4)
- Re: That is not what I meant. - bkearns 20:44:34 02/07/01 (3)
- Re: That is not what I meant. - garth 03:34:22 02/08/01 (1)
- Re: That is not what I meant. - bkearns 20:11:52 02/08/01 (0)
- Re: That is not what I meant. - Mel 23:40:54 02/07/01 (0)