Vinyl Asylum Welcome Licorice Pizza (LP) lovers! Setup guides and Vinyl FAQ. |
|
In Reply to: Downgrading...LP12 to Thorens TD150 MkII...Seeking Comments/Advice posted by JeffO on December 15, 2005 at 06:15:42:
Reverse situation - I had a Thorens TD160C with their TP16 tonearm before switching to an LP12.One problem I had - and it may be unique to that unit - was electrical noise "breakthough" from mains supply/motor to phono ouput signal cable.
It was not that obvious when I was still using an AT410 MM cartridge, but when I tried an MC (AT-OC5), it was overpowering - drowning the signal in a 50Hz "buzz". It was the primary reason for moving to the LP12.
I had taken the TD160 into the Thorens agents many times and they could not rectify the problem. To be fair, the problem may well have been in the TP16 tonearm and its harness - something the local agents in S. Africa were not equipped to change... :-(
I'd work on the premise that you will need to switch the tonearm, and the RB250 is good bet - just check on availability of armboards/mounts for the TD150 + RB250...
Have fun and check out any other feedback for any parallels in terms of electrical breakthrough...
:-)
"Don't roll those blood-shot eyes at me!"
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Re: Downgrading...LP12 to Thorens TD150 MkII...Seeking Comments/Advice - DevillEars 09:15:33 12/15/05 (1)
- Isn't the TD150 a better sounding table than the TD160? - Dick Schneiders 09:25:55 12/15/05 (0)