Thanks for the freezing tip. I should know that being from Alaska and also

Vinyl Asylum

Welcome Licorice Pizza (LP) lovers! Setup guides and Vinyl FAQ.

Follow Ups Full Thread

Topic - How would you cut a 9.5 cm hole in the center of a rubber mat? - viridian 15:56:33 12/22/21 (16)

Laser cutting - flood2 12:33:41 12/23/21 (4)

Happy holidays, Anthony and thank you. Must be Summer in your part of the world about now. nt - viridian 15:19:26 12/23/21 (3)

RE: Happy holidays, Anthony and thank you. Must be Summer in your part of the world about now. nt - flood2 15:34:47 12/23/21 (2)

Thanks! I needed that one. Nt - viridian 10:12:24 12/24/21 (0)

Boy, that's an old surfboard. nt - alaskahiatt 22:55:00 12/23/21 (0)

RE: How would you cut a 9.5 cm hole in the center of a rubber mat? - ChesshireCat 12:03:16 12/23/21 (2)

Thanks for the freezing tip. I should know that being from Alaska and also - alaskahiatt 23:01:37 12/23/21 (0)

Thank you for the tip Gary. nt - viridian 12:29:29 12/23/21 (0)

Unlimber the 12 ga. )MT( - J. S. Bach 04:06:09 12/23/21 (0)

You could try a tool like this . . . - alaskahiatt 17:37:46 12/22/21 (3)

RE: You could try a tool like this . . . - Ogsarg 09:03:08 12/24/21 (1)

Good idea. Thanks. nt - alaskahiatt 09:08:43 12/24/21 (0)

That is really cool, thank you! nt - viridian 18:01:48 12/22/21 (0)

RE: How would you cut a 9.5 cm hole in the center of a rubber mat? - John Elison 17:09:30 12/22/21 (2)

RE: How would you cut a 9.5 cm hole in the center of a rubber mat? - Joe Backer 17:32:58 12/22/21 (1)

Joe, I was thinking the same as John. That link is to a 9.5 mm punch, need cm. Nt - viridian 17:59:01 12/22/21 (0)

Follow Ups

Thanks for the freezing tip. I should know that being from Alaska and also - alaskahiatt 23:01:37 12/23/21 (0)

Post a Message!