Vinyl Asylum Welcome Licorice Pizza (LP) lovers! Setup guides and Vinyl FAQ. |
|
In Reply to: RE: VPI analog drive system (ADS) posted by Todd Krieger on November 7, 2021 at 22:46:04:
I wonder if your platter has excessive bearing drag. When you remove the belt and spin the platter by hand does it keep spinning a while or does it seem to stop fairly quickly?
My motor runs a bit warm, but it doesn't seem to be a problem. Of course, I don't have the same system you have. Mine is a prototype and it may use a different motor than yours. There were two different motors used in the prototype systems. Mine also might have some different electronics because its 3-phase amplifier that drives the motor is a separate component from the 3-phase generator/controller.
You might want to contact SOTA to find out if your motor temperature presents a problem.
Good luck,
John Elison
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: VPI analog drive system (ADS) - John Elison 04:07:10 11/08/21 (0)