97.82.221.142
This Post Has Been Edited by the Author
In Reply to: RE: going to upgrade some caps, maybe some advice needed posted by NuWave on January 13, 2021 at 13:58:30
You have to add fresh solder to melt old solder. Sometimes tinning, wiping and then tinning again will get it done, sometimes you have to touch the fresh solder to the old.
I use this one, good enough for occasional work
Quality solder wick is also necessary for boards and pulling apart point-to-point cleanly. You want NTE No Clean the only one I've found absolutely reliable. Use it holding the solder to it as though you were soldering it to the part or board and pulling/rubbing the wick across the part.
Any Damned Fool Knows One Horse Can Run Faster Than Another
Follow Ups: