Vinyl Asylum Welcome Licorice Pizza (LP) lovers! Setup guides and Vinyl FAQ. |
|
In Reply to: I have those posted by NuWave on January 13, 2021 at 17:22:55:
.....just touch your iron to the board and remove the rest from the hole with your solder sucker or wick, The wick may be easier here.
Yes, I prefer to see the caps in contact with the board as that acts as a stabilizing/damping element as regards vibration. When getting the new caps ready for install into the cleaned holes, push the leads through the holes, make contact between cap and board, and slightly bend the leads from the back to hold the cap in place. Solder the holes and, when the solder is dry, cut the leads with your clippers. Voila.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Once the old one and the leads are out... - viridian 18:12:08 01/13/21 (0)