"O rings on both sides could keep them in place" I used nuts and washers on my counterweight-less Syntec ...

Posted by J. S. Bach (A) on October 24, 2020 at 04:09:48

In Reply to: RE: Here's one approach posted by Byrd69 on October 23, 2020 at 16:40:43:

...s-220 tonearm until I got a proper setup:

Here is the proper setup complete with anti-skate:

Note thaat I noticed no real difference between the two.

Later Gator,
Dave

This post is made possible by the generous support of people like you and our sponsors:

Follow Ups Full Thread

Topic - Need to make a counterweight - Ariston RD40 - Byrd69 07:11:17 10/22/20 (14)

Here's one approach - Bill Way 09:48:28 10/23/20 (12)

RE: Here's one approach - Byrd69 16:40:43 10/23/20 (9)

"O rings on both sides could keep them in place" I used nuts and washers on my counterweight-less Syntec ... - J. S. Bach 04:09:48 10/24/20 (0)

RE: Here's one approach - pictureguy 16:47:55 10/23/20 (7)

RE: Here's one approach - Byrd69 18:14:11 10/23/20 (6)

RE: Here's one approach - pictureguy 19:49:02 10/23/20 (5)

Dang...the hole isn't threaded - Byrd69 10:22:26 10/24/20 (4)

RE: Dang...the hole isn't threaded - rivervalley817 11:05:49 10/24/20 (2)

I overthink buying a bag of oranges - Byrd69 12:09:19 10/24/20 (1)

RE: I overthink buying a bag of oranges - rivervalley817 12:34:03 10/24/20 (0)

RE: Dang...the hole isn't threaded - pictureguy 10:57:06 10/24/20 (0)

RE: Here's one approach - rivervalley817 10:00:21 10/23/20 (1)

RE: Here's one approach - Bill Way 13:06:15 10/23/20 (0)

RE: Need to make a counterweight - Ariston RD40 - Story 02:18:52 10/23/20 (0)

Follow Ups

"O rings on both sides could keep them in place" I used nuts and washers on my counterweight-less Syntec ... - J. S. Bach 04:09:48 10/24/20 (0)

"O rings on both sides could keep them in place" I used nuts and washers on my counterweight-less Syntec ...

Post a Message!