Vinyl Asylum Welcome Licorice Pizza (LP) lovers! Setup guides and Vinyl FAQ. |
|
In Reply to: Here's one approach posted by Bill Way on October 23, 2020 at 09:48:28:
I don't have the rod or the weights. All I have is a threaded hole to go by. I tried a couple bolts from the tractor supply today to see if I could get one to thread. Nope...too coarse. It may be 7/16 dia, but I need finer threads.If I can get the right threaded rod, I'm certain I can load it with brass washers. There would be no need to have set screws for them. O rings on both sides could keep them in place. Epoxy works wonders too.
Crude but possibly quite effective.
Your interest may vary but the results will be same. (Byrd 2020)
I can't compete with the dead. (Buck W. 2010)
Cowards can't be heroes. (Byrd 2017)
Why don't catfish have kittens? (Moe Howard 1937)
Edits: 10/23/20
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: Here's one approach - Byrd69 16:40:43 10/23/20 (9)
- "O rings on both sides could keep them in place" I used nuts and washers on my counterweight-less Syntec ... - J. S. Bach 04:09:48 10/24/20 (0)
- RE: Here's one approach - pictureguy 16:47:55 10/23/20 (7)
- RE: Here's one approach - Byrd69 18:14:11 10/23/20 (6)
- RE: Here's one approach - pictureguy 19:49:02 10/23/20 (5)
- Dang...the hole isn't threaded - Byrd69 10:22:26 10/24/20 (4)
- RE: Dang...the hole isn't threaded - rivervalley817 11:05:49 10/24/20 (2)
- I overthink buying a bag of oranges - Byrd69 12:09:19 10/24/20 (1)
- RE: I overthink buying a bag of oranges - rivervalley817 12:34:03 10/24/20 (0)
- RE: Dang...the hole isn't threaded - pictureguy 10:57:06 10/24/20 (0)