Vinyl Asylum Welcome Licorice Pizza (LP) lovers! Setup guides and Vinyl FAQ. |
|
In Reply to: I goofed up !! posted by Tom B. on October 15, 2020 at 17:42:11:
If you can solder, you can do it.
You don't need to strip the wire; the soldering pencil heat will do that for you. Try it - touch the hot soldering pencil to the end of the wire. Or you can take a single-edged razor blade and scrape it against the insulation for the last 1/8th of an inch or so. (It's really hard to try to slice around the insulation as you would for bigger wire.) Remove the cartridge clip from the back of the cartridge and put it in a pair of hemostats or something to hold it. Tin it and remove any strands of wire hanging on. Then bring the wire to the clip and apply heat to melt the solder, holding the pencil tip at the joint of wire and clip.
WW
"Put on your high heeled sneakers. Baby, we''re goin'' out tonight.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: I goofed up !! - Bill Way 18:40:23 10/15/20 (1)
- Was gonna suggest this. - ghost of olddude55 06:37:38 10/16/20 (0)