Vinyl Asylum Welcome Licorice Pizza (LP) lovers! Setup guides and Vinyl FAQ. |
|
In Reply to: RE: Cartridge alignment and tonearm design posted by John Elison on July 7, 2020 at 09:44:57:
Hi, John,
I wonder if the difference in bearing offset could be measured/observed using an analyzer or perhaps a Fozgometer. Align for the inherent tonearm geometry, e.g., Stevenson's, and then align for Lofgren A and see if the change in distortion is detectable at specific groove radii. My hunch is that the scale on the Foz isn't fine enough to detect such small differences but a good spectrum analyzer might.
Tom
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: Cartridge alignment and tonearm design - tketcham 06:35:39 07/08/20 (6)
- RE: Cartridge alignment and tonearm design - flood2 02:31:59 07/11/20 (1)
- RE: Cartridge alignment and tonearm design - tketcham 04:20:54 07/11/20 (0)
- RE: Cartridge alignment and tonearm design - John Elison 07:16:52 07/08/20 (3)
- RE: Cartridge alignment and tonearm design - tketcham 09:58:27 07/08/20 (2)
- RE: Cartridge alignment and tonearm design - John Elison 10:40:00 07/08/20 (1)
- RE: Cartridge alignment and tonearm design - tketcham 12:20:03 07/08/20 (0)