|
Vinyl Asylum Welcome Licorice Pizza (LP) lovers! Setup guides and Vinyl FAQ. |
|
|
|
Vinyl Asylum Welcome Licorice Pizza (LP) lovers! Setup guides and Vinyl FAQ. |
|
In Reply to: RE: Phono cable requirements? posted by greg7 on January 28, 2013 at 02:58:04:
Some MM cartridges require a cap. of 400. Most require 100 to 200. Now that you know what your cables are, you now need to know what your phono stage settings (cap./resistance),settings are. Are they adjustable? Are they fixed and if so, what are they fixed at. If fixed at let say 200 cap. and your cables are 140 (total 340), and you are using a cartridge that wants to see 100, you might wind up with a sound that is a little bright. Then again, your system might roll off the top end and this setup might just improve your overall sound.
I'm not saying this is the right way to boost top end responce, just stating what would be the effect with the settings mentioned.
Cap./Res. only change the Frequence Responce and can not hurt anything so mount your cartridge and give it a try. You now know what you can do to alter the responce of what it produces. Reduce cap. if it's to bright, or raise it if it's to dull. Do it with your phono stage setting if their available. If not, then you will have to do it with cables. It really is all about what sounds right to you.
Regards,
Don
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: Phono cable requirements? - griffithds 09:14:46 01/28/13 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2025, Audio Asylum, all rights reserved ]
