|
Vinyl Asylum Welcome Licorice Pizza (LP) lovers! Setup guides and Vinyl FAQ. |
|
|
|
Vinyl Asylum Welcome Licorice Pizza (LP) lovers! Setup guides and Vinyl FAQ. |
|
In Reply to: Very Interesting! Thank you.... posted by John Elison on October 25, 2012 at 23:02:49:
I've asked everyone I know to try to obtain the bearings I want but so far to no avail. They are stainless pivot bearings, made by NSK Micro in Japan.
Jonathan Carr of Lyra was going to ask the manufacturer directly but haven't heard anything back.
Mark Kelly
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Bearings - Mark Kelly 23:47:18 10/25/12 (15)
- The testy tone - Mark Kelly 03:11:25 10/27/12 (0)
- While not a pivot bearing - unclestu 21:48:47 10/26/12 (1)
- Nope. - Mark Kelly 23:12:37 10/26/12 (0)
- RE: Bearings - directdriver 09:54:21 10/26/12 (10)
- Dat's der bunny - Mark Kelly 15:19:23 10/26/12 (8)
- RE: Dat's der bunny - Tre' 17:17:56 10/26/12 (7)
- Tried and failed. - Mark Kelly 17:42:54 10/26/12 (6)
- Mark, Timken also produces pivot bearings. - hagustos 01:17:55 10/27/12 (5)
- Maybe you should ask Hadcock UK tonearm manufacturer - hagustos 02:24:55 10/27/12 (3)
- Oxymoron - Mark Kelly 02:54:32 10/27/12 (2)
- They really used one pin and 4 ball in a cup bearing set for their unipivot tonearms ... - hagustos 09:00:27 10/27/12 (1)
- OK thanks I didn't know that - Mark Kelly 00:32:10 10/28/12 (0)
- Yep, also unobtainium - Mark Kelly 01:41:17 10/27/12 (0)
- RE: Bearings - dtut 10:30:23 10/26/12 (0)
- RE: Bearings - dtut 08:50:50 10/26/12 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2025, Audio Asylum, all rights reserved ]
