RE: TD124/VPI 9T Project

Posted by FSonicSmith (A) on August 3, 2012 at 15:55:26

In Reply to: RE: TD124/VPI 9T Project posted by gotoma8 on August 3, 2012 at 12:32:36:

Good question. There is no way to go inboard the way VPI does it due to the cast iron top plate of the TD124 which rises above the already-too-high arm board so going outboard is the only practical option. As to anti-skate, if you think about it, the tonearm has no way of "knowing" the difference-wire twist is wire twist. According to my Fozgometer, the wire twist from the outboard orientation is doing it's job just fine.

This post is made possible by the generous support of people like you and our sponsors:

Follow Ups Full Thread

Topic - TD124/VPI 9T Project - FSonicSmith 07:52:04 08/03/12 (14)

armboard - LousyTourist 04:56:40 08/04/12 (1)

RE: armboard - obscomp@msn.com 08:34:36 08/04/12 (0)

RE: TD124/VPI 9T Project - AudioSoul 16:30:53 08/03/12 (0)

RE: TD124/VPI 9T Project - FSonicSmith 07:55:01 08/03/12 (2)

RE: TD124/VPI 9T Project - gotoma8 12:32:36 08/03/12 (1)

RE: TD124/VPI 9T Project - FSonicSmith 15:55:26 08/03/12 (0)

RE: TD124/VPI 9T Project - FSonicSmith 07:54:17 08/03/12 (7)

RE: TD124/VPI 9T Project - gotoma8 11:34:46 11/29/12 (1)

RE: TD124/VPI 9T Project - FSonicSmith 11:56:34 11/29/12 (0)

Beautiful table... - fishy 08:30:02 08/03/12 (4)

RE: Beautiful table... - FSonicSmith 08:43:19 08/03/12 (3)

It shoul not be glued down - Jim Austin 08:46:25 08/03/12 (2)

RE: It shoul not be glued down - FSonicSmith 09:10:49 08/03/12 (1)

Nope. - Jim Austin 09:11:52 08/03/12 (0)

Follow Ups

RE: TD124/VPI 9T Project - FSonicSmith 15:55:26 08/03/12 (0)

RE: TD124/VPI 9T Project

Post a Message!