|
Vinyl Asylum Welcome Licorice Pizza (LP) lovers! Setup guides and Vinyl FAQ. |
|
|
|
Vinyl Asylum Welcome Licorice Pizza (LP) lovers! Setup guides and Vinyl FAQ. |
|
In Reply to: VPI tonearms and Soundsmith styi posted by teenage diplomat on July 18, 2012 at 09:33:21:
It tracked better with a Rega than with a knife edge SME. It tracked worse in a unipivot.
The motor is off square. So the cartridge needs to be tipped a couple of degrees to get azimuth aligned properly.
I cannot do this as easily with a unipivot because of the stylus friction. It will work to pull the FG or Shibata types square to the grooves but the motor is still out a few degrees.
With these situations I just have to use certain misaligned motors in a cartridge to play on fixed bearing arms and properly aligned motor assemblies go on my unipivot arm.
The nice thing is when you realize it is not you that are creating the nasties it becomes easier to move forward.
Jim
"Help support our school's Music programs"
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- I had a bunch of issues with my Grado - tubesforever 10:19:52 07/18/12 (2)
- Hmm, haven't a problem with Grado Master/Morch UP-4 w/blue armtube. But I use a non-tech method. - Rick W 12:20:56 07/18/12 (0)
- RE: I had a bunch of issues with my Grado - paulfairall 10:44:32 07/18/12 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
