Vinyl Asylum Welcome Licorice Pizza (LP) lovers! Setup guides and Vinyl FAQ. |
|
In Reply to: What are you using to measure the 2-degree angle? posted by hesson11 on March 24, 2012 at 12:22:22:
I downloaded a pdf protractor, printed it, then scribed a line at the 2 degree mark, I then cut it precisely with a lever arm paper cutter to get a straight 2 degree edge. I used an old beat up but straigh vinyl record placed it on the turntable, held the bottom edge of the on the vinyl surface, drpped the tonearm down in a groove, then drpped the arm till the other edge was in line with the front verticle edge of the cart. My arm on my MMF 5 was adjusted almost to the bottom of its travel about 6 playing cards from the bottom to reach this 2 degree mark. This 2 degrees is what grado reccomends and measuring from the front verticle edge of the cart is also there recomendation. I dont think i have ever dropped the arm this far in the past for my other carts, but 2 degrees is 2 degrees.
I have to run but i will describe the sound later when i return
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: What are you using to measure the 2-degree angle? - JDN 07:56:57 03/25/12 (1)
- Aha! - hesson11 16:47:07 03/25/12 (0)