|
Tweakers' Asylum Tweaks for systems, rooms and Do It Yourself (DIY) help. FAQ. |
|
|
|
Tweakers' Asylum Tweaks for systems, rooms and Do It Yourself (DIY) help. FAQ. |
|
In Reply to: RE: Micro Drill Bits posted by B. Scarpia on November 25, 2022 at 01:52:03:
I am a long time user of solder wick as well. Recently I have run into problems, I think because of the nature of solder used on circuit boards after the '70s. Some of that rubbery garbage will simply not wick out of a feed through, even after multiple uses of flux and additional 'good' solder to thin out the rubbery garbage. Several times I have had to resort to a pin to puncture through the thin sheet remaining in the center of the feed through. Otherwise getting to trace lifting time, which is another bad thing.
If you have a solution to lifting the crap rubbery solder, then I would really like to know about it. All part of the craft, I think...
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: Micro Drill Bits - rogerh113 07:01:28 11/25/22 (5)
- Stubborn Solder - Jonesy 08:41:44 11/25/22 (4)
- RE: Stubborn Solder - rogerh113 08:46:07 11/25/22 (3)
- RE: Stubborn Solder - Jonesy 13:34:31 11/25/22 (2)
- RE: Ebay Link - B. Scarpia 07:33:57 11/26/22 (1)
- RE: Ebay Link - Jonesy 12:02:05 11/27/22 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2025, Audio Asylum, all rights reserved ]
