Tweakers' Asylum Tweaks for systems, rooms and Do It Yourself (DIY) help. FAQ. |
|
In Reply to: DIY Speaker Jumpers Question posted by greg7 on January 16, 2021 at 16:59:21:
I recommend leaving solder out of the situation, since with a "partial solder joint" the flux may flow into the wire/connector interface within the connector and affect conductivity, which is not a good thing. If you are concerned about oxidation, use some heat shrink to seal the termination points. Just make sure to use a heavy-duty crimping tool for the task, and apply severe pressure for a gas-free termination, greg7.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: DIY Speaker Jumpers Question - Duster 02:43:43 01/17/21 (0)