Tweakers' Asylum Tweaks for systems, rooms and Do It Yourself (DIY) help. FAQ. |
|
I need to replace a bulging cap in a NAD receiver. In order to get the pcb out I need to disconnect one end of this ribbon cable. But I'm not quite sure how it mates with its counterpart on the pcb. And I certainly don't want to damage it. I lightly pulled on one end of the connector with some small needle nose pliers but nothing seemed to be giving. Anyone have experience with this type of connector? Is the white connector a female end, and the pcb has male pins? Thanks in advance...
This post is made possible by the generous support of people like you and our sponsors:
Topic - need some help with this connector - BS64 13:29:40 11/15/20 (6)
- Thanks to Ugly, and everyone else who contributed - BS64 13:31:17 11/16/20 (0)
- RE: need some help with this connector - Ugly 10:15:00 11/16/20 (0)
- RE: need some help with this connector - Duster 07:16:25 11/16/20 (0)
- RE: need some help with this connector - fmak 23:38:23 11/15/20 (0)
- RE: need some help with this connector - Story 14:24:18 11/15/20 (1)
- RE: need some help with this connector - Uncle Mike 03:26:56 11/16/20 (0)